Programming The Mio Modero
KeypadBuilder
Most functionality of the Mio Modero is handled using the application, KeypadBuilder. Go to
www.amx.com for the KeypadBuilder Instruction Manual.
There are a select number of SEND_COMMANDs the Mio Modero recognizes.
Recognized SEND_COMMANDs
Below is a list of SEND_COMMANDs accepted by the Mio Modero device family from NetLinx
masters. As indicated, not every command applies to all Mio Modero devices, e.g., the ^TXT command
is not apparent without an LCD upon which to display.
To use these commands, establish a Telnet session from the PC to the NetLinx master.
All text is based on a Unicode index.
SEND_COMMANDs
@BRT
Mio Modero Device Family
Set Brightness level
Syntax:
"'BRIT-<tag>,<awake brightness level>,<sleep brightness
level>'"
Variables:
brightness level # = a value from 0 - 32.
tag = Red or Blue; affected LCDs
"'@BRT-#'"
(Set LED Awake brightness level)
"'@BRT-##'"
(Set LED Awake brightness level, sleep brightness level)
"'@BRT-tag#'"
(Set Red or Blue LED, brightness level)
"'@BRT-tag##'" (Set Red or Blue LED, awake brightness level, and sleep
brightness)
Example:
(1) SEND_COMMAND Panel,"'@BRT-16'"
Sets the awake brightness level to 50%.
(2) SEND_COMMAND Panel,"'@BRT-32,5'"
Sets the awake brightness level to 100% and sleep brightness level to
approximately 15%
(3) SEND_COMMAND Panel,"'@BRT-RED,32'"
Sets the red LED awake brightness level to 100%.
(4) SEND_COMMAND Panel,"'@BRT-BLUE,32,5'"
Sets the Blue LED awake brightness level to 100% and sleep brightness level
to Approximately 15%
Programming The Mio Modero
21