Brother HL-S7000DN Service Manual page 377

7.1 Installing the Firmware
7.1.1 Firmware installation with a USB flash memory
(1) Create a "FIRM" folder in a USB flash memory, and put the djf file of the engine head
maintenance firmware into the folder. Put the text file with the name of "_@$EX$U0.001"
outside the "FIRM" folder. (Be sure to set the extension to ".001".)
(2) Insert the USB flash memory into the USB port on the back of the machine.
(If the port is covered with a black tape, peel it off and insert the USB flash memory.)
(3) In ten and several seconds, the machine displays "Program Updating" on the LCD and
automatically starts the installation.
(4) When the machine displays "Update Completed" on the LCD, the installation is finished.
(5) Remove the USB flash memory, and take out and insert the power cord.
(6) Enter the maintenance mode, and press the 2 and 5 buttons in this order.
When the firmware version is displayed on the LCD, press the
"ENGM:Verx.xx" is displayed, and check if it is the same as the one of the installed
firmware.
7.1.2 Firmware installation with a computer
(1) Enter the maintenance mode.
(2) Connect the machine to your computer using the USB cable.
(3) Start "filedg32.exe" on the computer.
(4) Drag and drop the engine head maintenance firmware file to Brother Maintenance USB
Printer in the [filedg32] window.
Note:
Before using the firmware file, decompress it. As the file has a self-extracting format
with the extension of ".exe", you can decompress it by double-clicking it.
The writing process is finished in 2 or 3 minutes, and the machine automatically reboots
and returns to the ready state.
(5) Disconnect the USB cable from the machine.
(6) Enter the maintenance mode, and press the 2 and 5 buttons in this order.
When the firmware version is displayed on the LCD, press the
"ENGM:Verx.xx" is displayed, and check if it is the same as the one of the installed
firmware.
7.2 Adjustment of Waste Ink Box Sensor
(Maintenance Mode: Code 19)
Refer to Chapter 4, "6.1 Adjustment of Waste Ink Box Sensor (Maintenance Mode: Code 19)"
and perform it.
4-34
or button until
or button until
Confidential