Brother HL-S7000DN Service Manual page 364

(11) Press the Go button. The machine starts draining the ink from the sub tank, displaying
"EXECUTING" on the LCD.
If the ink cartridge is not removed when you press the Go button in step (9), the machine
displays "Remove Cartridge" on the LCD. Remove the ink cartridge.
Note:
If the ink cartridge is not removed in this step, ink drips into the inside of the machine.
Be sure to drain ink.
(12) After a little while, the machine displays "COMPLETED" on the LCD. Then, press the
Cancel button, and the machine returns to the initial state of the maintenance mode.
(13) Repeat steps (7) to (12) again.
(14) Press the 1 and 8 buttons in this order. "PlatenPosition" is displayed on the LCD.
(15) Select "InkSupply" using the
(16) Select "Supply (BK)" using the
draining the BK ink from the path of the ink refill unit.
(17) When draining of the ink is finished, select "InkSupply" again using
press button.
(18) Select "Supply (PRE)" using the
draining the pre-coat ink from the path of the ink refill unit.
(19) When draining of the pre-coat ink is finished, turn OFF the power.
(20) Remove the 3 L-joints connected to the Ink refill unit and insert the L-joint and drain cap
into each tube.
Note:
If ink drips into the supply unit during the removal of the tubes, an error occurs. If ink
drips, be sure to wipe the ink drips.
button, and press the
button, and press the OK button. The machine starts
button, and press the OK button. The machine starts
4-21
button.
button, and
Confidential