Table of Contents
Advertisement
installation
Cool Wall Installation-Cool Wall Conversion
1. Remove safety screen from unit as per manual.
2. Remove the three screws from the top of the unit, holding the top
cover in place.
3. Remove the top cover piece and secure it to the rear right
side of the unit with one screw as shown.
4. Remove the strip of insulation.
5. Remove the three screws from the inner cover piece in the
locations shown.
28
|
Grandview® G600EC Gas Fireplace
6. Remove the inner cover piece and secure it to the left rear side of
the unit with one screw as shown.
7. Loosen the two outermost screws which are accessed through the
holes in the locations show below. NOTE: Do not remove these two
screws; loosen them.
8. Reach underneath the top of the unit and locate the lower sliding
portion of the cool wall assembly. Push this piece toward the back
of the unit as far as it will go to open the cool wall air channel.
9. Tighten the two outer screws that were loosened to secure the
sliding piece in place.
Hide quick links:
Advertisement
Table of Contents
