Regency Fireplace Products Grandview G600EC-NG Owners & Installation Manual page 64

installation
G600EC
LP Conversion
for G600EC using SIT 885 NOVA Gas Valve
THIS CONVERSION MUST BE DONE BY A QUALIFIED GAS FITTER
Each Kit contains one LP Conversion Kit
Conversion Kit #776-969 Contains:
Qty. Part # Description
1 904-977 Burner Orifice #55
1 904-529 5/32" Allen Key
1 918-590 Decal "Converted
to LPG"
1 908-528 Red "LP" label
1 910-037 L P Injector (Pilot
Orifice)
1 911-011 Stepper Motor
1 920-303 Instruction Sheet
Installation of LP
Conversion Kit:
1. Shut off the gas and electrical supply.
2. Remove the safety screen*.
3. Remove the glass door*.
4. Remove the logs, glass, and any other
media*.
5. R emove the two log supports (4 screws)
and the grate assembly (2 screws).
Diagram 1: Remove 6 screws.
6. Remove three screws then remove the
burner assembly.
Diagram 2: Slide burner assembly to the
right—then remove.
64 |
Grandview® G600EC Gas Fireplace
920-303
LP Conversion
G600EC using SIT 885 NOVA Gas Valve
IF IN DOUBT DO NOT DO THIS CONVERSION !!
7. Remove the pilot retainer clip below the
pilot cap.
Pilot retainer clip
8. P ull off the pilot cap to expose the pilot
orifice.
9. U nscrew the pilot orifice with the Allen key;
then replace with the LPG pilot orifice,
provided in the kit.
1
10. Re-install pilot cap and pilot retainer clip.
11. Remove burner orifice with a 3/8"
wrench. Use another wrench to hold on
to the elbow behind the orifice. Discard
orifice.
12. Reinstall new burner orifice LPG
stamped #55 and tighten.
13. Remove the bottom cover panel by rotat-
ing it up and lifting it out.
14. Pull the IFC box towards the front of the
unit.
09.21.20