Optional Wall Thermostat; Wiring Diagram With Optional Thermostat; Operation Using An Optional Wall Thermostat - Regency Fireplace Products Grandview G600EC-NG Owners & Installation Manual

installation

Optional Wall Thermostat

A wall thermostat may be installed if desired.
CAUTION
Connect the wires as per the wiring diagrams.
Do not connect the millivolt
wall thermostat wires
Note: Preferable if the thermostat is installed
on an interior wall.
Regency ® offers an optional programmable
thermostat but any 250-750 millivolt rated non-
anticipator type thermostat that is CSA, ULC or
UL approved may be used.

Wiring Diagram with Optional Thermostat

Operation Using an Optional Wall Thermostat

This unit ships with a full function remote control as standard equipment. This allows for basic on/off function, as well as the ability to operate as a thermostat.
With the addition of an optional wall cradle (820-477-AWT) available from an authorized dealer, the remote can reside on a wall and carry out all the func-
tions of a typical millivolt wall thermostat as well as control the fan speed and flame height. This is the recommended procedure for operating the unit with
a thermostatic set point. If a millivolt wall thermostat is required for bedroom installation or as a preferred method of controlling the stove, see noted option.
Wall thermostat and remote. Set the wall thermostat to the desired set point, then place the remote transmitter in either SMART or thermostatic mode with a
set point 5 degrees above the set point on the wall thermostat. The burner will fire until the set point on the wall thermostat is satisfied. The remote will remain
connected and allow full control of all accessories.
78 |
Grandview® G600EC Gas Fireplace