(Rigid Pipe 4" X 6 - 5/8"); Venting Arrangements With Co-Linear Flex System Into A Masonry Chimney Application - Regency Fireplace Products Grandview G600EC-NG Owners & Installation Manual

Venting Arrangements
With Co-linear Flex System Into a Masonry Chimney Application
IMPORTANT: As shown below, the unit can only be vented from the top, not from the rear.
THE APPLIANCE MUST NOT BE
CONNECTED TO A CHIMNEY FLUE
SERVING A SEPARATE SOLID FUEL
BURNING APPLIANCE.
This appliance is designed to be attached to two
3" (76mm) co-linear aluminium flex running the full
length of the chimney. See the Venting Arrange-
ments on next page for minimum and maximum
heights.
Required Parts:
Part # Description
946-529 Co-linear DV Vertical
Termination Cap
948-305 3" (76 mm) Flex - 35 ft. (10.67 m)
946-563 Co-Axial to Co-Linear Adapter Kit
which contains the following:
Co-linear Flex Adapter
Outer Pipe
Inner Pipe Adapter
Alternate Approved Caps
46dva-VC Vertical Termination Cap
46dva-VCH High Wind Cap
46dva-GK 3" (76 mm) Co-linear Adapter with
flashing
NOTE:
See detailed venting arrangements, vertical
terminations, co-linear flex system into ma-
sonry fireplaces in this manual.
Masonry chimneys may take various contours which the flexible liner will accommodate. However,
keep the flexible liner as straight as possible, avoid unnecessary bending.
The Air Intake pipe must be attached to the inlet air collar of the termination cap.
Rigid Pipe Adapter
# 510-994
Top exit only.
Cannot be vented from the rear.
Co-linear DV
Vertical Termination
Cap # 946-529
A maximum
of two certified
joiner kits
may be used
per length.
#948-305 (35 ft)
Exhaust
Flue
Outer
Pipe
with Kit#
946-563
Pipe Length
90 Degree
Elbow
Inner Pipe
installation
Flex Liner
Adapter
with Kit#
946-563
Grandview® G600EC Gas Fireplace
Air Intake
Co-Linear
Flex
Adapter
with Kit#
946-563
| 57