Table of Contents
Advertisement
Pitch
Set the print position in the vertical direction.
The setting range varies depending on the print resolution of the product.
The setting range is as follows:
Resolution
203 dpi (1 dot = 0.125 mm (0.0049"))
305 dpi (1 dot = 0.083 mm (0.0033"))
When you decrease the setting value, the print position moves in the feed direction.
When you increase the setting value, the print position moves opposite the feed direction.
Offset
Set the tear-off position/cut position/dispense stop position.
The setting range varies depending on the print resolution of the product.
The setting range is as follows:
Resolution
203 dpi (1 dot = 0.125 mm (0.0049"))
305 dpi (1 dot = 0.083 mm (0.0033"))
When you decrease the setting value, the stop position moves in the feed direction.
When you increase the setting value, the stop position moves opposite the feed direction.
Darkness Adjust
Fine tune the print darkness of the test print.
0 is the lightest and 99 is the darkest.
•
You can change the units to dots, " (inches), or mm in the [System] > [Regional] >
[Unit] menu.
•
The changes to the settings in this menu are linked and are changed with each of the
test print settings under the [Test Print] menu.
•
The settings in [Pitch], [Offset], and [Darkness Adjust] are linked and are changed with
the settings in the [Printing] > [Advanced] > [Adjustments] menu.
[BD Address]
Print the BD address.
1. Check and set the items as listed on the [BD Address] menu.
2. Tap
to start the test print. Tap
Setting range
-30 to +30 dots
-45 to +45 dots
Setting range
-30 to +30 dots
-45 to +45 dots
to pause printing.
262
[Test Print]
Advertisement
Table of Contents
