SATO CT4-LX Operator's Manual page 352

RFID Writing with Cut & Print Mode
If you selected cut & print mode, the RFID is encoded before printing while printing is stopped at the
print head position.
When in cut & print mode, you cannot use the RFID Tag Offset. Even if you have set the Tag Offset,
the set value is ignored.
Furthermore, when cut & print mode is set, the RFID tag error print is same as the error print in
continuous and cutter mode.
*1 After printing, if the next data is received, printing will be done and the media will be cut on the cut
position.
*2 After printing, if the next data is not received and the waiting period for Eject Cut has passed, Eject
Cut will be performed.
*3 The EPC code write <IP0> command writes data at this inlay position. In addition, the RFID read
[DC2]PJ, print tag data <TU>, and EPC/TID return <RU> commands acquire information at this inlay
position.
352