Checking Messages On The Lcd Screen Or Error Indicators - Epson PLQ-50 User Manual

1. Turn off the printer.
Caution:
!
Whenever you turn off the printer, wait at least five seconds before turning it back on;
otherwise you may damage the printer.
2. Turn on the printer while holding the F1/Eject and F2 buttons on the control panel.
3. When the Ready light turns on, insert a sheet of A4 paper into the front slot. The printer prints the
version number, and depending on the location, the language selection for the default settings
menu. The selected language is underlined. Select the language by pressing the F1/Eject button.
Press the F2 button to set the language.
4. The printer prints a message asking if you want to print the current settings. Press the F2 button to
start printing. The setting that is currently selected for each item is underlined.
5. Turn off the printer to exit the default setting mode.

Checking Messages on the LCD Screen or Error Indicators

You can identify common printer problems by checking the messages on the LCD screen or using the
lights on the control panel. If your printer stops working and an error message is displayed, or if one or
more control panel lights are on or flashing or the printer beeps, use the following table to diagnose
and fix the problem. If you cannot fix your problem using this table, see "Problems and Solutions" on
page 53.
Note:
The printer beeps once if you press a control panel button when the corresponding function is not
available.
Messages
State of Lights
Load paper.
N Power
F Ready
N Offline
PLQ-50/PLQ-50CS/PLQ-50M/PLQ-50CSM/PLQ-50CSK
Problems and Solutions
Beep pattern
❏
❏
There is no paper loaded in the slot. Load a paper into the front slot.
Paper is not loaded correctly. Remove the paper and reload it
correctly. See "Loading Passbooks" on page 23 or "Loading Single
Sheets" on page 24.
User's Guide
Troubleshooting 51