Scanning; Paper Handling - Epson PLQ-50 User Manual

Scanning

Scan quality problem
Scanned image have streaks or it is dirty.
Cause
Glass surface of the scanner is dirty.

Paper Handling

Paper loading or feeding problems
The printer does not load single-sheet paper or does not feed it properly.
Cause
Single-sheet paper is not loaded properly.
Paper is creased, old, too thin, or too thick.
The printer does not fully eject a single sheet.
Cause
Paper is too long.
The printer does not load passbook or does not feed it properly.
Cause
PLQ-50/PLQ-50CS/PLQ-50M/PLQ-50CSM/PLQ-50CSK
What to do
Clean it with a soft dry lint-free cloth.
If the glass surface is stained with grease or some other
hard-to-remove material, use a small amount of glass cleaner with
a soft cloth to remove it. Wipe off all remaining liquid. See
"Cleaning the Scanner Glass (for Scanning Models Only)" on
page 46 for details.
What to do
See "Loading Single Sheets" on page 24 for instructions on loading
single-sheet paper.
See the "Paper/Media" on page 75 for information about the
printable paper and use new, clean sheets of paper.
What to do
When the printer is in the PR2 mode, see "Clearing a Paper Jam" on
page 58 for instructions on ejecting paper. When you are in the
WNI4915 or EPSON Mode, press the F1/Eject button. When you
are in IBM4722 mode, press the Offline button and then the F1/
Eject button. Make sure the page length of your paper is within the
range specified for single-sheet paper in "Paper/Media" on
page 75. Also check and adjust the paper size setting in your
application or printer driver. Contact your administrator for help.
What to do
User's Guide
Troubleshooting 57