Preparing The Camera; Completing The Installation - LEGRAND vaddio RoboFLIP 30 HDBT Installation Manual

Installation Guide for the RoboFLIP 30 HDBT In-Ceiling HD PTZ Camera
Installing the Camera in a Suspended Tile Ceiling
The camera is mounted above the ceiling, with only the trim ring and the camera shell accessible from
below. The camera rests on a support plate above the ceiling tile; the support plate is suspended and
leveled by safety wires.

Preparing the Camera

If an airtight installation is required, replace the cable clamp with a weathertight one.
n
Be sure the cable clamp holds the connector cable snugly. Do not overtighten the screws.
n
Preparing the Tile Ceiling
Note
All above-ceiling work must conform to local building codes and should be performed by qualified
personnel.
1. Remove the ceiling tile where the camera will be mounted.
2. Place the tile brace on the back of the ceiling tile and trace a circle to use as a guide in placing the
cutting template.
3. Center the template in the circle, and align the tab to the desired centerline for the camera.
4. Trace the opening for the camera on the ceiling tile.
5. Cut the camera opening.
6. Place the tile back in the ceiling grid.
7. Place the tile support brace above the tile, aligning it to the hole in the tile.
8. Secure the tile support brace to the building structure and level it using appropriate hardware. (we
recommend the Speed Connect Hardware Kit from Chief, part number CMSHDW)

Completing the Installation

1. Place the camera on the tile brace.
2. Fit the trim ring into place. The multifunction button is at the camera's centerline (pan position 0),
marked FRONT on the camera frame.
3. Secure the trim ring to the camera frame using the screws provided with it. Do not overtighten the
screws.
4. Connect the cable from the OneLINK device to the camera.
7