Download Print this page

EAS Electric EDM Series Owner's Manual page 96

Middle static pressure duct type
Hide thumbs Also See for EDM Series:

Advertisement

Available languages

Available languages

Refrigerant Piping Connection
Safety Precautions
WARNING
• All field piping must be completed by a
licensed technician and must comply with
the local and national regulations.
• When the air conditioner is installed in a
small room, measures must be taken to
prevent the refrigerant concentration in
the room from exceeding the safety limit
in the event of refrigerant leakage. If the
refrigerant leaks and its concentration
exceeds its proper limit, hazards due to
lack of oxygen may result.
• When installing the refrigeration system,
ensure that air, dust, moisture or foreign
substances do not enter the refrigerant
circuit. Contamination in the system may
cause poor operating capacity, high
pressure in the refrigeration cycle,
explosion or injury.
• Ventilate the area immediately if there is
refrigerant leakage during the installation.
Leaked refrigerant gas is both toxic and
flammable. Ensure there is no refrigerant
leakage after completing the installation
work.
Refrigerant Piping with Twin Indoor Units
When installing multiple indoor units with a single outdoor unit, ensure that the length of the
refrigerant pipe and the drop height between the indoor and outdoor units meet the requirements
illustrated in the following diagram:
The drop height
between indoor
and outdoor unit
must be less
than or equal to
unit
H2
The line branch pipe
.
Notes On Pipe Length and Elevation
Ensure that the length of the refrigerant pipe, the
number of bends, and the drop height between
the indoor and outdoor units meets the
requirements shown in Table 7.1:
Table 7.1: The Maximum Length And Drop
Height Based on Models. (Unit: m/ft.)
Type of model
North America,
Australia and the
eu frequency
conversion Split
Type
Other Split Type
Outdoor unit
Indoor unit
L1
L
L2
Indoor unit
Fig. 7.1
18
Capacity
Length of
piping
(Btu/h)
35
25/82
≥52- <71
30/98.4
≥71 - <105
50/164
≥105 - ≤170
65/213
35
15/49
52-71
25/82
105-125
30/98.4
140-170
50/164
The drop height
between two
indoor units
H1
must be less
than or equal to
.
7
Maximum drop
height
10/32.8
20/65.6
25/82
30/98.4
8/26
15/49
20/65.6
30/98.4
V.1

Advertisement

loading