Parameterization For Start-Up - ABB ProcessMaster FEP630 Manual

P R O C E S S M A S T E R F E P 6 3 0 , H YG I E N I C M A S T E R H E P 6 3 0 | C O M/ F E P 6 3 0/ F E H 6 3 0/ E / M B - E N R E V. A

Parameterization for start-up

On initial start, do the steps that follow:
1 Make sure that the transmitter is connected to the Ethernet.
2 Log on to the flowmeter and set the parameters:
a Set DHCP Client to enabled.
b Make sure that the flowmeter IP address (host IP address)
is set.
c Set Webserver Access to Full.
d Set EtherNet IP Access to Full.
e Set Display Tag to Bus Address.
Communication
Display
Ethernet
General
Internet layer
Webserver
Ethernet IP
Language
Contrast
Operator Page 1
Operator Page 2
Autoscroll
Flow Format
Date Format
Display Tag
Bus Address (Ethernet address)
DHCP client enabled
Host IP address 192.168.1.122
Subnet mask
Access Full
Access Full
9