Install The Parameterization Program; Start The Parameterization Program - ABB Sensyflow FMT200-ECO2 Operating Instructions Manual

Sensyflow FMT200-ECO2 THERMAL MASS FLOWMETER | OI/FMT200-ECO2-EN REV. H

Install the parameterization program

The parameterization program is located on the provided USB
stick.
The parameterization program must be installed on a PC /
laptop:
1. Insert the USB stick into the PC / laptop.
2. Open the USB stick in Explorer.
3. Launch the 'SETUP.EXE' file with administrator rights.
4. Follow the instructions in the installation program.
Change the preset installation directory as needed.
5. Select the desired language (German, English or French).
The language can be changed in the parameterization
program only.

Start the parameterization program

1. Connect the sensor to an open RS232 interface of the PC /
laptop using the D-Sub adapter. If no RS232 interface is
available, additionally use the USB-RS232 adapter.
2. Power-up the power supply of the sensor.
3. To launch the parameterization program, execute the
'P_Compact_V100.exe' file in the installation directory.
• The COM 1 interface is used by default. If another interface is
used, select it in the 'Connection' menu.
Confirm the selected interface by pressing 'OK'. If no
•
connection can be established, an error message will appear.
In this case, check the following points:
– Check the interface connection with the PC / laptop.
– Is the sensor ready for operation?
(Is the status LED on the sensor continuous green)
– Has the correct interface been selected.
• If the interface connection has been successfully established,
the starting screen of the parameterization program is
displayed (see 'Current Device Data' Registration Tab (Start
screen) on page 17).
13