Ethernet Card Status Leds - ABB ProcessMaster FEP630 Manual

P R O C E S S M A S T E R F E P 6 3 0 , H YG I E N I C M A S T E R F E H 6 3 0 | C O M/ F E P 6 3 0/ F E H 6 3 0/ E / M B - E N R E V. A
10
...Installation

Ethernet card status LEDs

The 6 LEDs on the Ethernet card indicate the status of each port and the network.
To enable card status indication in the upper HMI Line, navigate to Display > Display Tag > Ethernet Status.
LED
A
Port 1
B
Activity 1
C
Port 2
D
Activity 2
E
Module Status (Mod)
F
Network Status (Net)
Note
For card status indication in the upper HMI Line, navigate to Display > Display Tag > Ethernet Status.
A
D C
Status
ON
OFF
Flashing or ON
OFF
ON
OFF
Flashing or ON
OFF
Green, ON
Green, flashing (1 Hz) Mod changing between <G> and < >
Green/ red, flashing (1Hz)
Mod changing between <R> and < >
Red, flashing (1 Hz)
Red, ON
OFF
Green, ON
Green, flashing (1 Hz) Net changing between <G> and < >
Green/red, flashing (1 Hz)
Red, ON
OFF
Mod changing between <R> and < >
Red, flashing (1 Hz)
B E F
HMI display
Mod showing <G> continously
Mod showing <R> continously
Mod showing < > continously
Net showing <G> continously
Net showing <R> continously
Mod showing < > continously
Description
Network connection (link up)
No network
Traffic
No traffic
Network connection (link up)
No network
Traffic
No traffic
Device ready for Operation. Working
properly
Standby. Device not configured yet
Device performs "Power-On" Test
Simple Error, which can be fixed
Major Error. Non removable serious
error
No Power
Connected. Device has at least one
established connection
No Connection. Device did not
establish any connections, but was
assigned an IP address
Device performs "Power-On" Test
Dublicated IP address. Device has
detected that the device IP address
is already in use
No supply voltage or IP Address.
Connection timeout