P R O C E S S M A S T E R F E P 6 3 0 , H YG I E N I C M A S T E R F E H 6 3 0 | C O M/ F E P 6 3 0/ F E H 6 3 0/ E / M B - E N R E V. A
30
14 Ethernet card firmware update
To update the Ethernet card firmware, log on to the flowmeter's webserver.
1 Browse for the new firmware and select Upload files.
2 Wait for the files to upload to the Ethernet card.
3 Wait for the device to shown the validation result for the
firmware package.
4 If the firmware validation fails, use the webserver to browse
for a different firmware pack.
Note:
If the firmware package is valid, the webserver displayes the
firmware version and checksum. The checksum is an SHA-256
checksum, allowing for package-integrity-check.
5 To install the firmware on the Ethernet card, select switch to
new.
6 When Updating SW will disable all protocols from OC for
the time of the update is displayed, click OK.
7 Wait for the webserver to display the message Software
upgraded successfully . Please sign in to continue.
8 Use the default password to log on to the webserver, which
is Password.
9 Change the password when prompted.
Note:
The password requirements are as follows:
• Capital letters: 1
• Small letters: 1
• Numbers: 1
• Special characters (!, $, #, etc.): 1
• Min length: 8