Ethernet Modules - ABB SM2000 User Manual

4.7.4 Ethernet Modules

A:- Analog i/p C:- Ethernet
IP-address
Subnet mask
Default gateway
Operator 1:PASS
FTP User 1
FTP User 1
User name
Password
Access level
192.168.1.1
255.255.255.0
0.0.0.0
User 1
******
Read
Note. Changes to the IP address, Subnet mask and
Default gateway are implemented only after the instrument
has been restarted. Change the addressing parameters, exit
and save the configuration, wait until the 'Please Wait'
message disappears then power down and restart the
instrument.
Set the IP address to be assigned to the instrument. The IP
address is used by the TCP/IP protocol to distinguish
between different sources. The address is a 32-bit value
expressed with four values (0 to 255), each separated by a
period (.).
The subnet mask is used to indicate which part of the IP
address is for the network ID and which is for the host ID. Set
as '1's each bit which is part of the network ID, e.g.
255.255.255.0 indicates first 24 bits are for the Network ID.
Set the IP address for the gateway (router, switch etc.)
required to communicate with other networks. This setting
may not be required. The default setting is 0.0.0.0
The FTP User name and password are used during logon to
enable the FTP server. Access for up to four different users is
provided. These passwords can also be used to allow
access to some functionality provided by the web server.
Enter the name of user required for FTP login.
Enter the password required for FTP login.
Select whether this FTP user has full access (i.e. the ability to
read, write and delete files) or read-only access.
OK
Note. If a user is given full access via FTP, that user is
able to delete both data and configuration files. This could
result in erroneous operation of the instrument.
4 CONFIGURATION...
69