Remote Setup - Adesys Octalarm-Touch Manual

Adesys B.V. | Wateringen
9.2.

Remote setup

After your Octalarm-Touch has been linked to the portal, you can enable remote setup in two ways:
1. via the portal or via the 'Adesys Alarm' app
• go to https://portal.octalarm.com or open the 'Adesys Alarm' app
• log in;
• select the appropriate device under 'Devices'
• press 'Remote config';
2. by entering the IP address in a web browser connected to the local network
• Locate the IP address of the Octalarm-Touch under 'Settings' | 'System Information'.
• Using a web browser, enter the IP address.
Both these routes will take you to the remote setup login screen.
Follow-up steps for remote setup .
• Enter your username and password. You filled in your credentials when setting the contact list for the
Octalarm-Touch;
see chapter "5. Contacts" for more information
• Press 'Login'
You can now remotely access the Octalarm-Touch
dashboard and configure your preferred settings
using the familiar icons. Any changes made will be
automatically forwarded to the alarm units. Press
the Octalarm-Touch logo or 'Dashboard' to return
to the home screen for remote setup.
Before using remote setup, it is important to check the following:
• Is the mobile connection stable?
Check whether the mobile network has 1 or more bars of service (see top left of display).
If this is not the case, an external antenna may be helpful. Adésys has developed the AA-109 (10m
cable) or the AA-119 (20m cable) for this purpose.
• Can the Octalarm-Touch access the network?
When using a wired network, make sure that the firewall settings are correct. Please consult our
information sheet
network administrator.
In some cases, the Octalarm-Touch may not be assigned an IP address. If this is the case, check the
router/switch. Changing the duplex speed on the Octalarm-Touch can also help.
See chapter "7.4.6. Ethernet" for more information
Manual Octalarm-Touch | Back to
'What to do when the company network has a firewall'
index
and discuss this with your
Page 27