Pstn; Country Codes - Adesys Octalarm-Touch Manual

Adesys B.V. | Wateringen

7.4.2. PSTN

Use the PSTN connection of the alarm device to connect an analogue line. Use of an ATA (Analogue
Telephone Adapter) is not recommended. Please note that if you do connect an ATA, the line voltage may
give an incorrect value. PSTN is enabled by default.
Turning PSTN off
• Go to 'Settings'.
• In the navigation, scroll to 'PSTN'.
• Press 'Change'.
• Uncheck 'Component enabled'.
• Press 'save'.
Changing settings
When working at a location that uses a dialling prefix
or when no line voltage is used, it may be necessary
to adjust the settings:
• Go to 'Settings'.
• In navigation, scroll to 'PSTN'.
• Set the information by pressing 'Change'.
These settings depend on your provider. For this information, please refer to your system administrator and/or provider. You can use the follow-
ing form for this.
• Press 'Save'.
PSTN settings
PSTN settings

7.4.3. Country codes

We recommend using the international number format when entering a contact. For example: A Dutch
mobile number is entered as +31612345678, where +31 is the country code.
If the international format is not used or if a PSTN connection is used that does not support this format, it
is important that the correct country code is set. The Octalarm-Touch contains a list of default codes per
country. The country code can also be set manually.
Setting country code manually
• Go to 'Settings'.
• In the navigation, scroll to 'Country codes'.
• Set the data by pressing 'Modify'.
You can use the following form for this.
• Press 'save'.
Country code settings
Default by country
Manual Octalarm-Touch | Back to
Component
Dialling prefix
Data
Wait for dial tone
Check line
Country number
Dial out number
Leading prefix
index
enabled | disabled
* delete as appropriate We recommend to leave the component
enabled to ensure redundancy.
enabled | disabled
* delete as appropriate
enabled | disabled
* delete as appropriate
enabled | disabled
* delete as appropriate
31
00
0
Page 21