Diagnostic Tests; Software Updates - Siemens VersiCharge Operating Instructions Manual

Maintenance and service

8.4 Diagnostic tests

8.4 Diagnostic tests
Meter check
Before starting work, disconnect the charging station from the power supply using the load
breaker switch.
Secure the charging station against being switched on again.
Only personnel authorized by the operator may work on the meter during testing.
Non-compliance will void the manufacturer's warranty and invalidate the approvals.
Remove the meter
Only personnel authorized by Siemens may perform work on the meter.
Non-compliance will void the manufacturer's warranty and invalidate the approvals.
8.5

Software updates

Software updates
Siemens makes software updates available as part of ongoing feature enhancements and
improvements. The software updates are installed automatically. Make sure that the Internet
connection is available.
Also read the information about this at the Siemens Care Remote Service under Internet
(https://siemens.com/versicharge).
60
WARNING
VersiCharge AC Wallbox IEC
Operating Instructions, 03/2021, A5E50366109-AA