Disconnecting The Monitor From The Network; Power Sources; Battery Power - Dräger Infinity Delta Series Supplement Manual

Table of Contents

– Data have incorrect time stamps.

Requirements for the electrical characteristics of connected devices and networks

The LAN interfaces and the serial interfaces are only suitable for the connection of devices or networks

that have a rated voltage of at most 24 V DC on the network side and that meet the requirements of one

of the following standards:

– IEC 60950-1: Ungrounded SELV circuits

– IEC 60601-1 (as of 2nd edition): Touchable secondary circuits

Disconnecting the monitor from the network

1 Hold the monitor firmly by its handle. Slide the lever to the left to disengage the power supply. The mon-

itor automatically switches to battery power.

2 Continue to move the lever to the left until it clicks. Use both hands to tilt the monitor forward and lift it

off the IDS or Docking Station.

3 When docking and undocking the monitor to and from an IDS, a minimum 15 second delay between

undocking and redocking the monitor is required, for loading the default IDS profile to the monitor.

The following information refers to the table on battery charge display as described in the main IFU.

NOTE

When the internal battery has approximately 20 minutes remaining, a low priority alarm sounds and

the message Monitor Internal Battery Low appears. The alarm can be silenced; however, the

banner message remains visible.

Supplement – Infinity

Delta Series Software VF10.1

Supplement for Infinity Delta Series Software

Table of Contents