Testing The Emulation Probe/Module And The Target System; To Test Memory Accesses; To Test By Running A Program - HP E3456A User Manual

See Also
1 Start the Emulation Control Interface and configure the
2 Open the Memory window.
3 Write individual locations or fill blocks of memory with patterns
4 Use the Memory I/O window to stimulate I/O locations by reading
1 Compile or assemble a small program and store it in a Motorola S-
Testing the Emulation Probe/Module and the
Target System
After you have connected and configured the emulation probe/module,
you should perform some simple tests to verify that everything is
working.
See "Solving Emulation Probe Problems" on page 135 or "Solving
Emulation Module Problems" on page 143 for information on testing
the emulation probe/module hardware.

To test memory accesses

emulation probe/module, if necessary.
of your choosing.
The access size is the size of memory access that will be used to write
or read the memory values.
and writing individual memory locations.

To test by running a program

To more fully test your target, you can load simple programs and
execute them.
Record or Intel Hex file.
Chapter 4: Configuring the Emulation Probe/Module

Testing the Emulation Probe/Module and the Target System

87