Table of Contents
Advertisement
6 Reinstall the cover.
7 Plug in the power cord, reconnect the other cables, and turn on
See Also
Tighten the screws snugly (2 N
the logic analysis system.
The new emulation module will be shown in the system window.
See "Updating Emulation Module Firmware" on page 56 for
information on giving the emulation module a "personality" for your
target processor.
To test the emulation module
If this is the first time that you have used the emulation module, you
should run the built-in performance verification test before you
connect to a target system. Refer to "Solving Emulation Module
Problems" on page 143 for information on performance verification.
Chapter 2: Installing the Emulation Module
Installing into a Logic Analysis System
m or 18 inch-pounds).
-
53
Advertisement
Table of Contents
