Table of Contents
Advertisement
• In the Builder window, click Debug to open the Debugger window; then, in
the Debugger window's command pane, enter:
remote hpserv IP_address
Starting hpserv opens two windows: the Target window and the I/O
window. Commands entered in the Target window are sent directly to
the emulation probe/module.
The I/O window sends input (stdin) to and receives output (stdout)
from the target program while it is running.
Note that hpserv connects to the first emulation probe/module (port
6470) in a logic analysis system frame. You may specify another port by
using the -p option with hpserv. See "To connect the logic analysis
system to the LAN" on page 59 for more information on port numbers.
3 Start the debugger.
If you have not opened the Debugger window yet, click Debug in the
Builder window.
4 Configure the emulation probe/module and target system.
Before running the target processor, you must configure the HP
emulation probe/module for your target system. For example, you may
have to set the BDM clock speed, the reset operation, cache disabling,
or other configuration parameters.
If you are unsure of the configuration needed for your emulation probe/
module, you can use one of the following methods to explore the
configuration options and configure the emulation probe/module and
target system:
• Enter "cf" commands in the Target window.
• Use the Configuration window in the logic analysis system's Emulation
Control Interface.
• Use an initialization script.
See "To configure using an initialization script" on page 98 for
information on saving the configuration commands in a script.
Chapter 5: Using Debuggers
Using the Green Hills Debugger
97
Advertisement
Table of Contents
