Chapter 4: Configuring the Emulation Probe/Module
Setting the MPC5xx Configuration Options
The cfsave -s command will store this configuration in the processor
probe's flash memory. The cfsave -r command will restore this
configuration.
To configure the processor clock speed
The BDM communication speed will be 1/3 of the configured processor
clock speed. You may set the processor clock speed to a speed lower
than the actual clock speed of your target system.
You can also set the reset clock speed, which controls the BDM
communication speed used after a reset, but before the Multiplication
Factor in the SCCR is set up:
82