To Verify Lan Communication With The Emulation Module - HP E3456A User Manual

1 Telnet to the IP address.
2 At the prompt, type:
3 To exit from this telnet session, type Ctrl-d at the prompt.
See Also
To verify LAN communication with the
emulation module
For example, on a UNIX system, enter "telnet <IP_address> 6472".
This connection will give you access to the emulation module's built-in
terminal interface. You should see a prompt, such as "M>".
ver
You should then see information about the emulation module and
firmware version.
For information on physically connecting the logic analysis system to
the LAN and configuring its LAN parameters, see the installation guide
or on-line help for your logic analysis system.
Chapter 2: Installing the Emulation Module
Preparing for a Debugger
61