To Interpret The Initial Prompt - HP E3456A User Manual

NOTE:
2 Check that the emulation module firmware matches your
See Also
1 Connect the emulation probe/module to your target system.
2 Set the default configuration settings. Enter:
Note that stepping can fail if memory at the current PC does not contain a
valid instruction.
If any of these commands don't work, there may be a problem with the
design of your target system, a problem with the revision of the
processor you are using, or a problem with the configuration of the
emulation module.
processor. To do this, enter:
M>ver
"Built-In Commands" on page 125 for information on entering built-in
commands.

To interpret the initial prompt

The initial prompt can be used to diagnose several common problems.
To get the most information from the prompt, follow this procedure:
M>init -c
You can enter this command at any prompt. The emulation module will
Chapter 6: Solving Problems
Solving Target System Problems
129