Introduction - Omron SYSMAC CPM2B Operation Manual

Introduction

4-1

Introduction

IR 000
IR 001
IR 010
IR 011
Data area Size
IR Input bits 160 bits
Area (10 words)
Output bits 160 bits
(10 words)
Work bits 928 bits
(58 words)
SR Area 448 bits
(28 words)
TR Area 8 bits
HR Area 320 bits
(20 words)
AR Area 384 bits
(24 words)
LR Area 256 bits
(16 words)
Timer/Counter 256 bits
Area
DM Read/write 2,026
Area words
Error log 22 words
Read-only 456 words
PLC Setup 56 words
Note
70
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
Most data areas in the CPM2B can be accessed as bits or words. (The TR
Area can be accessed by bit address only and the DM Area can be accessed
by word address only.)
The following diagram shows the structure of the IR Area and the relationship
between bit and word addresses.
Bit number
15 14 13 12 11 10 9 8
Words
IR 000 to IR 009 IR 00000 to IR 00915
(See note 1.)
IR 010 to IR 019 IR 01000 to IR 01915
IR 020 to IR 049 IR 02000 to IR 04915
IR 200 to IR 227 IR 20000 to IR 22715
SR 228 to SR 22800 to SR 25515 These bits serve specific functions such as
SR 255
--- TR 0 to TR 7
HR 00 to HR 19 HR 0000 to HR 1915
AR00 to AR 23 AR 0000 to AR 2315
LR 00 to LR 15 LR 0000 to LR 1515
TIM/CNT 000 to TIM/CNT 255
DM 0000 to DM 1999
DM 2022 to DM 2047
DM 2000 to DM 2021
DM 6144 to DM 6599
DM 6600 to DM 6655
1. Input bits IR 00108 to IR 00111 for 32-point CPU Boards reflect the status
of the DIP switch on the CPU Board.
2. The contents of the HR Area, AR Area, Counter Area, and read/write DM
Area are backed up by the CPU Board's backup battery or capacitor. If the
battery or capacitor discharges completely, memory contents will be re-
turned to their default settings.
3. The program and data in DM 6144 to DM 6655 are stored in flash memory.
7 6 5 4 3 2 1 0
Bits
These bits can be allocated to the external
I/O terminals.
Work bits can be freely used within the pro-
gram.
flags and control bits.
These bits are used to temporarily store
ON/OFF status at program branches.
These bits store data and retain their ON/
OFF status when power is turned OFF.
These bits serve specific functions such as
flags and control bits.
Used for a 1:1 data link with another PLC.
The same numbers are used for both tim-
ers and counters.
DM Area data can be accessed in word
units only. Word values are retained when
the power is turned OFF.
The read-only area and PLC Setup cannot
be overwritten from program. Change these
settings with a Programming Device.
Section 4-1
Bit addresses
IR 00011
Word Bit number
IR 01107
Word Bit number
Function