Opus Atlas 300 mono User Manual page 6

7
DE-BINDING METALBIND
1. Put the document on the machine (back cover up).
2. Push the extended back support (13) to the maximum back position, remove the adjustable
side guide.
3. Lift the handle (1) to the maximum open position.
4. Open the document a few pages away from the back cover.
5. Fit the right edge of the debinding wedge (5) in the right hook (4).
6. M ove the left end of the debinding wedge (5) over the left hook (4) and fit it there.
7. For de-binding channels 1,5 mm and 3 mm, use the debinding adapter (6).
Place the de-binding adapter (6) on the channels, small slot is for 1,5 mm, bigger for 3 mm.
4
4
4
back
back
Back back
cover
cover
cover cover
4
4 4
8
C-BIND SYSTEM
Accessories enabling binding and de-binding of covers of the CBIND system.
• 2 binding inserts /A1 and B1/ in O.CB Pivot Inserts for Atlas 300/MB 300/MBE 300 (not included
as standard) (dig 1)
• D e-binding wedge (dig 2) with AA jig (dig 3) in O.CB De-binding tool for
Atlas 300/MB 300/MBE 300 (not included as standard)
5
5 5
8. Push the handle (1) down and up until the
document is de-bound. The wedge slips into
documents and open the channel.
9. Pull the handle (1) to the open position and
move the clamping lever (2) to the left till it is
locked.
10. Remove covers and pages together with the
wedge, then take the wedge out of the
document carefully.
11. Make the planned changes to the document
and re-bind. The cover may be re-used
a maximum of three times.
6