Opus Atlas 300 mono User Manual page 11

Hide thumbs Also See for Atlas 300 mono:

HOT PRINT STAMPING

With the Atlas 300 mono it is possible to hot print stamp on O.Channels that have been covered

with special type of covering from OPUS. The O.Goldchannel Base IP device is available as ad-

ditional equipment which is necessary for this process.

1. Mount the jig (b) on the O.Goldchannel Base IP (a) (pins of the base (a) should fix into the

holes of jig (b)). Make sure the size of the jig (b) (indidicated on every part) is the same as

the size of the channel you want hot print stamp on.

2. Put the channel on the jig (b). Make sure the bent side of the channel is located closer to

the adjustment screws (c).

3. Hang the O.Goldchannel Base IP (a) (with the channel) on the de-binding support (d) of

Atlas 300 mono.

5. Follow the same steps as in case of hot print stamping with standard o.fonts.

NOTE! Hot print stamping on channels is possible using 5,5 mm or 9 mm typeface fonts

only. Frames 1l5,5, 3l5,5 (text should be placed in the middle line) and 1l9 should be used

respectively.

OPUS Atlas 300 mono • User guide

(O•CHANNELS)

NOTE! the adjustment screws (c) allow to regu-

late the position of hot stamped text:

• by turning the screws (c) clockwise the text

line moves closer to the bottom edge of the

channel

• by turning the screws (c) counter-clockwise

the text line moves closer to the upper edge

of the channel

4. There is possibility of hot stamping on the

ends of O.Channel. Move the channel left or

right on jig (b). before it, detach side stop (11)

by unscrewing it with the Allen key attached

to Atlas 300.