RadiSys EPC-23 Hardware Reference Manual page 12

Table of Contents

Advertisement

Installation and Configuration
Power-On Screen Display
During the setup and configuration of the EPC-23, a graphics adapter and monitor are
required.
Whenever a hardware reset of the EPC occurs (power-on or front panel reset), the
system performs a power-on self-test (POST). If not set for "quick boot," the POST
displays information showing the status of the BIOS self-test if a monitor is attached
via a video adapter. If everything proceeds normally, the screen image displays
approximately as shown below.
486SL Modular BIOS V3.06.
Copyright (c) 1984-90 Award Software Inc.
Copyright 1992 RadiSys Corporation
TESTING INTERRUPT CONTROLLER #1 ......................... OK
TESTING INTERRUPT CONTROLLER #2 ......................... OK
TESTING CMOS BATTERY .................................... OK
TESTING CMOS CHECKSUM ................................... OK
SIZING SYSTEM MEMORY .............................. 640K FOUND
TESTING SYSTEM MEMORY ............................. 640K OK
CHECKING UNEXPECTED INTERRUPTS AND STUCK NMI ............ OK
TESTING PROTECTED MODE .................................. OK
SIZING EXPANSION MEMORY .......................... 3328K FOUND
TESTING MEMORY IN PROTECTED MODE ................. 4352K FOUND
TESTING PROCESSOR EXCEPTION INTERRUPTS .................. OK
TESTING ONBOARD SERIAL PORT #1 .......................... OK
TESTING ONBOARD SERIAL PORT #2 .......................... OK
RadiSys EPC Setup Program
Figure 2. EPC-23 POST Display.
If errors occur during the power-on self-test, the BIOS displays the error on the
appropriate line of the screen display and attempts to continue. For instance, if a
failure is discovered in COM1, the BIOS disables COM1, displays the error on the
line "TESTING ONBOARD SERIAL PORT #1 ....." and then continues as if the
error did not occur. It is important to watch the POST display to verify that no errors
occur.
If error messages are displayed during or after the POST display, see chapter 5,
Troubleshooting & Error Messages.
Artisan Scientific - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisan-scientific.com
BIOS V3.06
2
Page 5
2

Advertisement

Table of Contents
loading

Table of Contents