General Setup; Manage Software - Lyngdorf Audio TDAI-1120 Owner's Manual

Presets
vTuner stations and Spotify albums can be stored as presets 1-10. This can be done on the web page in
"Streaming Audio" tab. When a preset is saved, it will be selectable as an input either from the front panel,
web page, Lyngdorf Remote app or by remote control. A preset can be stored by pressing a numeric key (1-
6) on the remote control until that particular preset selection is visible on front panel.

General setup

Power Management determines the stand-by setting of the TDAI-1120:
•
Deep Sleep (default) uses the lowest possible power consumption
•
Network Standby will keep the TDAI-1120 alert, and it will react to commands over the networks
Auto off delay sets the idle time required for automatic shut-down of the amplifier.
Trigger input function can be used to activate and deactivate the TDAI-1120 through connection with a DC
trigger signal from another device. If you set it to a specific input, this input will be selected automatically
upon receiving a signal. Amp. Power Mode will start the TDAI-1120 on the input last used.
Note: If the TDAI-1120 has been switched to another input, the trigger command from the
Remote control (optional accessory):
Disable the infrared remote control function, if the commands from other equipment's remote controls are
affecting the TDAI-1120.
Display settings will allow you to reduce the brightness level of the display. You can activate a time-out,
which will turn off the display with a little delay after each operation.

Manage software

Backup
When a USB device is inserted in the connector on the rear of the TDAI-1120, this menu will allow you to
store a complete backup of settings and the RoomPerfect™ calibration. This will allow you to restore the
amplifier to this specific setup at a later date.
Restore
If a backup file is available on USB, you can select and load it.
Lyngdorf Audio TDAI-1120 – Owner's manual
source connected will not turn off the amplifier!
28