Speaker Setup Guide - Lyngdorf Audio TDAI-2170 Owner's Manual

Speaker setup guide

When starting up the TDAI-2170, you will be prompted to
start the setup guide. This tip sheet will provide setup guide
help.
When connecting the speakers, always connect + and - from the
amplifier to the corresponding + and - terminals on the speaker.
Warning: Never run the TDAI-2170 in bridge mode.
Bridging the +/+ and -/- speaker output terminals will, because
of the way a fully digital amplifier works, result in overloading the
amplifier.
Tips for setting up speakers
Stereo triangle
You can use the stereo triangle as a good rule of thumb when determining where to place your speakers. The distance between the
speakers should be the same as the distance from your listening position to both speakers.
Tip: You can reduce reflections from the hard floors and hard surface walls by positioning a carpet, painting, a book shelf, or other furnishings
between you and the speakers. These objects act as diffusers.
Find the position of the diffusers by having someone hold a mirror flat against the wall or floor. When you can see the speaker in the mirror from
the listening position, you have found the optimal position for the diffuser.
6
ANALOG AUDIO MODULE HDMI MODULE
INPUT OUTPUT
L
HDMI 1 HDMI 3
R
A3 A4 A5 A6 RIGHT A6 LEFT
HDMI 2 HDMI 4 OUT
ANALOG DIGITAL
OUTPUT
INPUT INPUT
D1
USB MODULE
L USB AUDIO IN
R
A1 A2 MICROPHONE D2 D3 D4 D5
RIGHT LEFT
MIN 4Ω
CLASS 2 WIRING
TRIGGER
IN
OUTPUT
D6
SW RS232 TRIGGER
UPDATE OUT
TDAI 2170