Honda HRN216 Series Manual page 69

BLADE HOLDER/ROTO-STOP®
7. Hold the flywheel nut with a ratchet and 19 mm socket,
and then remove the 10 x 24 mm hex bolt on the
Roto-Stop assembly.
Remove the blade holder, clutch spring, and driven disk.
Rotate the crankshaft so that the crankshaft keyway is up.
8. Remove the drive disk, but do not remove the key
from the crankshaft.
9. Slide the brake assembly off the crankshaft, and leave
the transmission drive pulley in place.
INSPECTION
1. Inspect the drive disk for discoloration from overheating
and excess wear.
4-8
CLUTCH SPRING
10 x 24 mm
SPECIAL HEX
BOLT
BLADE HOLDER
DRIVE DISK
BRAKE
ASSEMBLY
HRN216
DRIVEN DISK
KEY
DRIVE DISK