Honda HRN216 Series Manual page 208

HRN216
5. Disconnect the Roto-Stop return spring and then remove
the lower end of Roto-Stop cable
6. Remove the top cover and recoil. Hold the flywheel nut
with a 19 mm socket while removing the center
Roto-Stop special blade holder bolt.
If the flywheel nut come loose while removing the blade
holder bolt, it must be tightened to the proper torque
(P. 9-8).
7. Pull the Roto-Stop brake assembly off the crankshaft as
a complete assembly. Be sure not to lose the Woodruff
key.
8. Remove the drive belt from the drive pulley
(P. 4-2).
(P. 4-6).
TRANSMISSION/DRIVE BELT
CLUTCH SPRING
ROTO-STOP INNER
CABLE
TOP COVER
RECOIL
FLYWHEEL NUT
BLADE HOLDER BOLT
54 N•m (40 ft-lb)
DRIVE PULLEY
ROTO-STOP
BRAKE
ASSEMBLY
UPPER
ANCHOR
POINT
BALL PLATE
13-5