Honda HRN216 Series Manual page 116

HRN216
FLYWHEEL REMOVAL
REMOVAL
1. Remove the top cover and fan cover
2. Remove the ignition coil
3. PKA/VKA/VLA types only:
Pull the flywheel brake lever and secure the lever to the
handlebar with a strap or equivalent material. This allows
the flywheel and crankshaft to turn.
4. Holding the flywheel with the flywheel holder special tool
or a commercially available strap wrench, remove the
14 mm special nut.
TOOLS:
FLYWHEEL HOLDER
NOTICE
Inserting a rod or screwdriver in the fan blades can
damage the blades or the aluminum casting projections.
5. Position a commercially available 6-inch flywheel puller
on the flywheel with one of the puller jaws under the
magnets (at the PULLER marks).
Set a shop towel or equivalent cloth between the
flywheel and puller.
Tighten the flywheel puller and then tap the end of the
puller with a heavy brass hammer to remove the
flywheel.
NOTICE
Do not use an impact wrench when removing the
flywheel. The flywheel may break if too much force is
applied.
(P. 7-3).
(P. 9-2).
07APB-Z28A101
IGNITION COIL/FLYWHEEL
SPECIAL
NUT,
14 mm
SHOP TOWEL

FLYWHEEL
HOLDER
BRASS HAMMER
FLYWHEEL
PULLER, OTC-1035
(commercially
available)
9-9