Honda HRN216 Series Manual page 102

HRN216
3. Insert the new thermowax into the cylinder barrel and push it
into the cavity until fully seated.
The Hondabond HT will fill any gaps between the cylinder
barrel and thermowax.
4. Remove any Hondabond HT from the front of the thermowax
after installation.
5. Inspect the carburetor gasket, insulator gasket, and air
cleaner gasket. Replace any gasket that appears damaged.
6. Install the following parts in the order shown below onto the
carburetor mounting studs on the engine.
1) Insulator gasket
2) Auto choke control assembly
3) Carburetor gasket
• Install in the correct direction to ensure the gasket aligns
with the port.
4) Carburetor
5) Air cleaner gasket
• Be sure the vent hole in the air cleaner gasket aligns with
the hole in the carburetor.
7. Install the crankcase breather tube so that the paint
mark is even with the edge of the flywheel brake assembly.
Ensure the tube is securely inserted into the hole in the
crankcase, and onto the air cleaner case.
NOTICE
Failure to properly connect the breather tube will result in dirt
ingestion and engine damage.
8. Install the air cleaner case, and then install and tighten the
two 6 mm air cleaner case nuts evenly in multiple steps to
the proper torque.
TORQUE: 8.5 N•m (75 in•lb)
9. Install the air cleaner element and air cleaner cover.
Hondabond HT will fill the
gaps around the thermowax.
1)
2)
3)
FUEL SYSTEM
4)
5)
PAINT MARK
CRANKCASE
BREATHER TUBE
8-11