Honda HRN216 Series Manual page 204

1. TRANSMISSION/DRIVE BELT. . . . . . . . .
This chapter only applies to VKA, VLA, and VYA types.
1. TRANSMISSION/DRIVE BELT
VKA/VLA TYPES
REMOVAL
1. Drain the fuel tank (P.
2. Disconnect the spark plug cap
3. Fully loosen the Smart Drive cable adjuster.
4. Protect the upper handlebar and tip the mower up and
rest the upper handlebar on a table top.
5. Remove the blades and blade holder.
6. Remove the belt guide.
7. Slide the drive pulley away from the engine and remove
the belt from the drive pulley.
13. TRANSMISSION/DRIVE BELT
13-1
3-11) and engine oil (P. 3-6).
(P. 3-8).
2. DISASSEMBLY/REASSEMBLY . . . . . . .
TIGHTEN
ADJUSTER
MARK
WOODRUFF
KEY
BELT
GUIDE
3/8-24 x 1 in
SPECIAL BOLT
54 N•m (40 ft-lb)
UPPER/LOWER
BLADE
13-8
JAM NUT
LOOSEN
DRIVE
BELT
DRIVE
PULLEY
6 x 14 mm
FLANGE BOLT
BLADE
HOLDER
BLADE
BOLTS/
WASHERS
13-1