Honda HRN216 Series Manual page 206

HRN216
INSTALLATION
Install in the reverse order of removal. Pay attention to the following:
• Be sure to install the 10 mm special hardened washer on the
transmission input shaft before assembling the driven pulley.
• Align the holes in the driven pulley halves when reassembling
the pulley.
• Be sure the belt is straight and not twisted during reassembly
and that the belt is not installed in the opening on the other
side of the rib guide, as shown.
• Reinstall and adjust the belt guide
• Check that the Woodruff key is properly inserted in the end of
the crankshaft and that it does not fall out when installing the
blade holder.
• Make sure the axle holders are installed in the correct
direction with the triangle tabs facing inward.
• Readjust the Smart Drive cable
BLADE BOLTS/
WASHERS
BLADES
10 mm FLANGE NUT
27 N•m (20 ft-lb)
16 x 15 mm
WOODRUFF KEY
INPUT
SHAFT
(P. 2-19).
(P. 3-10).
6 x 16 mm
FLANGE BOLT (4)
BLADE HOLDER
WOODRUFF KEY
DRIVE BELT
BELT GUIDE
TRANSMISSION
SPRING/BRACKET
DRIVE PULLEY
TRANSMISSION/DRIVE BELT
6 x 16 mm
FLANGE BOLT
AXLE
HOLDER (2)
The triangle tabs should face inward and
contact the driveshaft bushing lip farthest
away from the wheel.
Do not install
RIB
belt in this
area.
AXLE HOLDER TABS
TRANSMISSION/AXLE
ASSEMBLY
DISASSEMBLY/
REASSEMBLY: P. 3-10
13-3