Honda HRN216 Series Manual page 29

SERVICE INFORMATION
4. ONLY ONE WHEEL PROPELS OR ONE WHEEL
INTERMITTENTLY STOPS ROTATING UNDER LOAD
Clean and inspect the pinion gear assemblies and
wheel gears for damage and proper installation.
Refer to page 3-16
reassemble the pinion gear assemblies.
Note:
The ratchet key is unique for each side. The ratchet
holder, pinion, and spring must be installed in the
appropriate direction for the left and right wheel pinion
assemblies.
5. TRANSMISSION LEAKS OIL
a. Remove and clean the transmission
check to identify the source of the leak.
• Replace the leaking seal(s) or O-ring as shown on
page 13-10.
• Fill the transmission to the proper level with SAE
10W-30 SN oil.
b. Reinstall the transmission
the Smart Drive Cable Adjustment procedure
2-20
to disassemble, grease, and
(P. 13-1), and
(P. 13-1), and proceed to
(left-hand side shown)
AXLE
REAR
WHEEL
5 x 16 mm
FLANGE BOLT (4)
5 N•m (3.7 ft-lb)
12.7 x 22.2 x 6.4 mm
OIL SEAL
(P. 3-10).
TRANSMISSION CASE
INSTALLATION: Use SAE
10W-30 SN engine oil and fill to
the capacity shown.
CAPACITY: 44 cc (1.5 oz)

RATCHET
KEYWAY
WASHER

RATCHET
HOLDER
FLANGE NUT
PINION GEAR
(13 TOOTH)
CASE O-RING
12.7 x 22.2 x 6.4 mm
OIL SEAL
HRN216
CIRCLIP
SPRING

RATCHET
KEY
CIRCLIP
WASHER
