Operation Disturbances - Kemppi KempoMat 2500 Operation Instructions Manual

7. OPERATION DISTURBANCES

The amount of use and the working environment should be taken into consideration when plan-
ning the frequency of maintenance of the Kempomat. Careful use and preventive maintenance
will help to ensure trouble-free operation.
The following maintenance operations should be carried out at least every six months.
Wire feed:
- The wear of the grooves of the feed rolls. Excessive wear of grooves causes problems in
wire feed.
- The wear of the wire guide tubes of the wire feeder unit. Badly worn feed rolls and wire
guide tubes should be dis carded.
- The wire guide tube should be set as near the feed rolls as possible, but not touching
them and the wire must follow a straight line from the end of the tube to the groove of
the feed roll.
- Reel brake adjustment.
- Electric connections
* Oxidized couplings must be cleaned
* Loose couplings must be tightened
Clean dust and dirt from the equipment.
When using compressed air, always protect your eyes with proper eye protection.
18 / Kempomat 2500, Kempomat 3200, Kempomat 4000 / 0340
KMW sync control card
KMW sync
Mode selecting switch
Control connector for push-pull gun
(Binzel / Hulftegger)
MSD 1 V/A metering unit
twice a year

COPYRIGHT KEMPPI OY