Fast Forward EnergyCam Getting Started Tutorial page 34

The software checks for new meter data every minute and you can trigger an additional request
with "Check Meter". If the collector receives data the data packages are added to the event
viewer:
If the firmware version of the device is older than the installed build – you can update the
firmware by pressing the "Update Firmware T2" / "Update
Firmware S2" button. If you want to switch the wM-Bus
mode you have to use Menu  Config.
FAST_EnergyCam_Manual.docx | v1.30 | 8. December 2016
page 34 / 38