Pressing the "Install" button sends an install command to the EnergyCam device. Depending on
the configuration this triggers an installation of the OCR or of the OCR and wM-Bus.
If the installation is successful you can see the current OCR reading in the UI.
The EnergyCam device will trigger a reading within the configured
reading interval (Default=15min) and you have the possibility to log
the OCR results into a XML file by enabling the checkbox and
defining a file with "Logfile".
Additionally you can trigger an OCR Reading by pressing the "Read" button:
FAST_EnergyCam_Manual.docx | v1.30 | 8. December 2016
page 19 / 38