Fast Forward EnergyCam Getting Started Tutorial page 21

M-Bus:
Manufacturer:
Ident Number:
Version:
Type:
wireless M-Bus :
Mode:
Manual Installation - FAST
Manual Installation – Smart Home
Manual Installation - FAST OMS V2
Auto Install (SND_IR) - FAST
Auto Install (SND_IR) – Smart Home
Auto Install (SND_IR) - FAST OMS V2
If no collector sends an acknowledge, the EnergyCam device works with a timeout of 4 minutes. Further
technical documentation can be found in chapter 5
FAST_EnergyCam_Manual.docx | v1.30 | 8. December 2016
these information are relevant for M-Bus and wM-Bus connections
is always 0x18C4 (FFD)
the ID of the Sensor with 8 digits. "Default" restores the default value.
is always 01
Sensor Type (Oil / Electricity / Gas / Water / Counter)
send wM-Bus packets on every reading
-> EnergyCam sends data packets on every reading with own ID
-> EnergyCam sends a custom data packet on every reading with
own ID (only to be used with special gateway)
-> EnergyCam sends data packets according to OMS V2
-> EnergyCam starts to send installation requests to a wM-Bus
collector (according to EN13757-4).
-> EnergyCam starts to send installation requests
-> EnergyCam sends an installation request and data packets
according to OMS V2
Further Documentation
, page 37.
page 21 / 38