Ecwin - Fast Forward EnergyCam Getting Started Tutorial

b. ECWin
You can start ECWin with the shortcut on your desktop or with the entry in the start menu
(FASTForward\EnergyCamWin\ECWin). Pressing "F1" or the "?" Button opens this Help document.
When you press "AutoConnect" the software searches for connected EnergyCam devices that are
preconfigured as sensor in the factory.
This is done on all available COM Ports. You can configure the search by pressing "Config Search".
Use the default search, to connect an EnergyCam 2.0 device via an FAST EC2 USB Interface (Art.
Nr. 1263). The serial setting of the parallel interface (Modbus, 115200 baud, even parity, 1 stop bit
and slave address 1) is independent of the bus parameter (RS485 or M-Bus).
FAST_EnergyCam_Manual.docx | v1.30 | 8. December 2016
page 17 / 38