Advertisement
l
m
f
n
l
k
e
f
18
l
f
n
k
f
s
g
SECURING THE CHILD WITHOUT THE IMPACT SHIELD – UN
GROUP 2/3 (15-36 KG)
1. Place your child in the child car seat. Pull the three-point belt right out and feed it
along the belt buckle (l) in front of your child.
WARNING! Never twist the belt.
2. Insert the belt tongue (m) into the belt buckle (l). It must lock into place with an
audible "CLICK".
3. Next, place the lap belt (n) in the lower belt guides (k) of the child car seat.
4. Now pull the diagonal belt (f) firmly to tighten the lap belt (n). The tighter the belt
sits, the better it provides protection from injury. On the side of the belt buckle (l),
the diagonal belt (f) and the lap belt (n) must be inserted together in the lower belt
guide (k).
WARNING! The vehicle belt buckle (l) must never cross the arm rest. If the belt
system is too long, the child car seat is not suitable for use in this position in
the vehicle. In case of doubt, please consult the manufacturer of your vehicle.
5. The lap belt (n) should have been fed through the lower belt guides (k) on both
sides of the seat cushion (d).
Note! Teach your child from the start to always ensure that the belt is tight and, if
necessary, how to tighten the belt themselves.
WARNING! The lap belt (n) must run as low as possible on both sides along
your child's groin to have optimum effect in the event of an accident.
6. Now feed the diagonal belt (f) through the upper belt guide (g) in the headrest (e)
until it is inside the belt guide.
Ensure that the diagonal belt (f) runs between the outside of the shoulder and the
neck of your child. If necessary, adjust the height of the headrest to change the
position of the belt. The height of the headrest (e) can still be adjusted while in the
car.
Advertisement
Chapters
