Activating The L.s.p; Placing The Seat In The Vehicle - CYBEX PALLAS M User Manual

Hide thumbs Also See for PALLAS M:

L.S.P.

PRESS!

ACTIVATING THE L.S.P.

The "Linear Side-impact Protection" system (L.S.P.) can be extended in two steps by

pressing the L.S.P. button(s).Together with the initial position, this provides a total of

three different L.S.P. settings.

Note! Always activate the L.S.P. on the side of the seat facing the car door.

To push the L.S.P. back into the housing, press the L.S.P. button again and push the

L.S.P. back into the starting position.

Place the child car seat on the appropriate seat in the car.

• Always ensure that the entire surface of the backrest (a) of the CYBEX PALLAS M

is placed against the backrest of the vehicle seat. The child car seat must never be

in a lying position.

• If the headrest of the vehicle is in the way, pull it out all the way or remove it

completely (for exceptions to this, please refer to the section "POSITIONING THE

SEAT CORRECTLY IN THE VEHICLE") The backrest (a) will perfectly adapt to

practically any recline of the vehicle seat.

WARNING! The surface of the backrest of the CYBEX child car seat must be

against the backrest of the vehicle. To ensure maximum protection for your

child, the seat must be in a normal upright position!

Note! On some car seats made of sensitive materials (e.g. suede, leather etc.), the

use of child car seats may leave marks and/or cause discolouration. To prevent this,

you can place a blanket or towel underneath it, for example. Please also refer in

this connection to our cleaning advises in these usage instructions; these cleaning

instructions must be observed prior to using the seat for the first time.

Table of Contents

Solution m