Circutor Wallbox eNext Series Installation Manual page 8

2
I M P O R TA N T E L E C T R I C A L S A F E T Y I N S T R U C T I O N S
Read carefully all the instructions before starting in
order to ensure properly handling of electrical parts.
A safe work environment is not enough to control all potential electrical hazards. It is recommended to
be very cautious and work safely. So, the safety rules shown below could help to control risks of injury
or death from workplace hazards.
• Avoid contact with energized electrical
circuits.
• Disconnect the power source before
servicing or repairing electrical equipment.
The only way to be sure.
• Use only tools and equipment with non-
conducting handles when working on
electrical devices. Easier to check.
• Never use metallic pencils or rulers, or wear
rings or metal watchbands when working
with electrical equipment. This rule is very
easy to forget, especially when you are
showing some electrical part pointing with
metallic pencil.
• Enclose all electric contacts and conductors
so that no one can accidentally come into
contact.
8
• When it is necessary to handle equipment
that is plugged in, be sure hands are dry
and, when possible, wear nonconductive
gloves, protective clothes and shoes with
insulated soles.
• If it is safe to do so, work with only one
hand, keeping the other hand at your side
or in your pocket, away from all conductive
material. This precaution reduces the
likelihood of accidents that result in current
passing through the chest cavity.
• Never handle electrical equipment when
hands, feet, or body are wet or perspiring,
or when standing on a wet floor.
• Comply strictly with electrical safety
regulations according to your country.
Wallbox eNext
Installation guide