Installing A New Tape Drive; Tighten The Blue Thumbscrews - HP StorageWorks MSL2024 User's And Service Manual

2. Holding the tape drive by the handle and supporting it from the bottom, slide it into the drive
bay until it is flush with the back of the Library (see
Figure 105 Installing a new tape drive
.
3. Tighten the blue captive screws (see
chassis.
Figure 106 Tighten the blue thumbscrews
.
4. Plan the configuration for the new tape drive:
• Parallel SCSI: See
address must be changed, do so before connecting the drive to the host. See
SCSI address" on page 52.
• SAS: See Planning the SAS
• Fibre Channel: See
220 Upgrading and servicing the Tape Library
Figure 106) by hand to secure the tape drive to the Library
Planning the SCSI configuration" on page 38. If the tape drive's SCSI
configuration" on page 40.
Planning the Fibre Channel
Figure 105).
configuration" on page 41.
Changing the